This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
en:sidebar:remoteapi:apiref:unit:get_report_settings [29/11/2013 12:31] 127.0.0.1 external edit |
en:sidebar:remoteapi:apiref:unit:get_report_settings [01/12/2014 13:55] 127.0.0.1 external edit |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| "speedLimit":<uint>, /* speed limit, km/h */ | "speedLimit":<uint>, /* speed limit, km/h */ | ||
| "maxMessagesInterval":<uint>, /* maximum interval between messages, seconds */ | "maxMessagesInterval":<uint>, /* maximum interval between messages, seconds */ | ||
| - | "dailyEngineHoursRate":<uint>, /* daily engine hours rate, hours */ | + | "dailyEngineHoursRate":<uint>, /* daily engine hours rate, seconds */ |
| "urbanMaxSpeed":<uint>, /* urban speed limit, km/h */ | "urbanMaxSpeed":<uint>, /* urban speed limit, km/h */ | ||
| "mileageCoefficient":<uint> /* mileage coefficient */ | "mileageCoefficient":<uint> /* mileage coefficient */ | ||
| + | "speedingTolerance":<uint>, /* allowed speeding, km/h (used if speedingMode = 1) */ | ||
| + | "speedingMinDuration":<uint>, /* min speeding time, seconds */ | ||
| + | "speedingMode":<uint> /* speeding detection mode: 0 - use speedLimit, 1 - use map data */ | ||
| } | } | ||
| </code> | </code> | ||
| + | |||
| + | If speedingMode = 0 and speedLimit = 0 then no any speeding table is built. | ||
|
